|
Forum Mediatec - Depozitul de Cartuse Consumabilele sunt pasiunea noastra! Vanzari online: www.mediatec.ro
|
Subiectul anterior :: Subiectul următor |
Autor |
Mesaj |
flotin2011
Data înscrierii: 28/Iun/2011 Mesaje: 9 Locație: Timisoara
|
Trimis: Mie Iun 29, 2011 4:19 pm Titlul subiectului: Canon IP5300 error B200 |
|
|
Buna sunt nou pe acest forum insa am si eu o problema cu o imprimanta Canon IP5300 si anume imi afiseaza eroarea B200(becul galben palpaie de 10 ori) si capul de printare nu se misca. am cautat eroarea si am gasit la descriere VH monitor Error. As dori ajutor in acest sens sau sfaturi pt a gasi rezolvare la problema mea. |
|
Sus |
|
|
mediatecar Site Admin
Data înscrierii: 16/Noi/2007 Mesaje: 2406
|
Trimis: Mie Aug 31, 2011 7:47 am Titlul subiectului: |
|
|
Zice asa pe fixya****:
Citat: | Try keeping the paper only in the bottom tray (there's a tray in the bottom) Try pulling any paper out of the top and just close that top tray. Open up the head so that u can see the ink cartridges and turn the printer on and off and maybe it will center itself again. If it's still not working (even if lights aren't red and print head wont align in the center) try manually moving the head back and forth like 18 times so you can lubricate that rail in the back that's holding it. After that, re-turn it off and on again. |
las care raspunde unu':
Citat: | Well every advice is the same except a little altered (use a warm cotton swab to clean inside machine and on print head channels) but then it says if possible replace print head but honestly this has become a primitive Machine for turning humans into corpses - buy a new one. |
http://****fixya****/support/t3029627-ip_5300_error_b200_10_blink_orange_green |
|
Sus |
|
|
|
|
Nu puteți crea un subiect nou în acest forum Nu puteți răspunde în subiectele acestui forum Nu puteți modifica mesajele proprii din acest forum Nu puteți șterge mesajele proprii din acest forum Nu puteți vota în chestionarele din acest forum
|
|